Tighten the strap around the bushing and crank it gently to the left. Be prepared for some water to come out, as there’s likely still a little pressure behind the valve. Do not unscrew the entire bushing all at once. Go slowly, let the water seep out and only take the bushing off.
Grease ensures your cartridge seals rather than leaks. Align the cartridge with the hot and cold lines on your shower. All Delta shower cartridges are marked. Usually with H/C stamps. Then, push the cartridge into the faucet. Make sure the indentations on the valve body align with the indentations on the cartridge.
Replace the washer if it appears cracked or worn. Use a socket wrench to loosen the screw holding the washer together. Remove the washer and insert a new one, then put the screw back on. If your tub faucet is still leaking after swapping out this piece, you may need to replace the faucet stem. 6.
How to Repair a Leaky Shower Faucet, Step by Step. Turn off the water supply to the shower. This may be in an access panel on the wall behind the shower, or you may have to shut off the main line as shown above. Remove the cap on the end of the handle. Remove the screw holding the handle on. This, again, will likely be a Philips screw.
Step 3: Remove the faucet handle. With the water supply turned off, it’s time to remove the faucet handle. Follow these steps to remove the handle: Locate the screw that secures the faucet handle to the valve stem or cartridge. It’s usually located under a decorative cap in the center of the handle.
3 days ago · Turn the water supply back on by opening the shutoff valve (under the sink) counterclockwise all the way until it stops or by turning the water back on at the main. Check for leaks around the faucet stem. If it leaks, tighten the bonnet nut until the leaking stops; again, be careful not to overtighten. Tighten the screws behind the faceplate of the diverter valve. If you attempt this fix but the water continues to pour or leak slowly from the bathtub spout after the shower diverter has been engaged, move on to the next step. Disassemble the shower diverter. If your diverter has a rotating valve, unscrew the nut at the stem of the diverter and B6eDy.
